We are a Clutch Cover Manufacturer. Let me share with y […]

We are a Clutch Cover Manufacturer. Let me share with you the precautions for clutch disassembly and assembly.
  The clutch is located in the flywheel housing between the engine and the gearbox. The clutch assembly is fixed on the rear plane of the flywheel with screws. The output shaft of the clutch is the input shaft of the transmission. When the car is running, the driver can step on or release the clutch pedal as needed to temporarily separate and gradually engage the engine and the gearbox, so as to cut off or transmit the power input from the engine to the transmission. Clutch is a common component in mechanical transmission, which can separate or engage the transmission system at any time. Its basic requirements are: smooth joining, rapid and thorough separation; convenient adjustment and repair; small outline size; small quality; good wear resistance and sufficient heat dissipation capacity; convenient and labor-saving operation.
  Disassembly and assembly of the clutch
  Clearance adjustment after installing the clutch
  That is, the movement clearance of the fork of the clutch cylinder is usually 10MM to 20MM. The clutch is working well and the pedal is reset normally.
  1. When removing the clutch pressure plate, pay attention to whether the clutch plate has followed to prevent the clutch plate from falling and hurting yourself.
  2. When the pressure plate is removed, someone needs to hang the pressure plate with a hook. Be careful not to injure yourself with the hook
  3. When installing the clutch disc, pay attention to the installation direction.
  4. After installing the pressure plate, check whether the foot of the pressure plate is in the correct position, whether it is too high or too low.
  We also have many other products, such as Truck Pressure Plate, welcome to visit our website!

Views: 93