EXPLORE

PAY ATTENTION TO EXAMINATION WHEN THE RELEASE BEARING IS DAMAGED

Update:12-02-2022
Summary:

    At present, the damage of the release bearing on th […]

    At present, the damage of the release bearing on the request is substantially caused by the long-term operation of the release bearing. That's to say when the motorist doesn't step on the clutch pedal, the release bearing is still in a working state and is fleetly rotating with the clutch pressure plate. But there are exceptions.

    Still, it can be judged that the release bearing is in a working state for a long time and the release bearing is burned, If there's no gap between the release bearing and the separation finger. However, it's ruled out that there's no problem with the external link of the separation medium If there's an interval.

     Still, it's necessary to check the external link part, where is the problem that caused the release bearing and the release cutlet to die If there's no space between the release bearing and the release cutlet. This includes

     Check that the return spring is out. When the vehicle is in use, the clutch return spring falls off in constant bumps. When the motorist releases the clutch pedal, the release bearing can not be fully separated from the release cutlet and returns to the original state due to the spring falling off, and the release bearing is in a working state for a long time. The performance is that the clutch half-clutch position is over and down.

    Check the wear of the hole and link leg from the link leg hole of the rocker arm and the link of the link separation stroke arm. Remove the drive rod from the separation rocker arm and check whether the leg hole has egregious abnormal wear. The hardness of the separation rocker arm or link leg doesn't meet the conditions. Later long- term gyration and disunion, the wear will be serious. After the wear reaches a certain position, separation will do. deficient miracle.

    Rotate the separation rocker arm to check whether it rotates flexibly. Due to poor road conditions (causing the needle comber bearing in the clutch casing, especially the top needle comber bearing installed by Liwu to fluently enter dust or erode, performing in poor gyration of the separating chopstick shaft, the pressure of the return spring alone can not When the separation dial is pulled back to its original position, the separation bearing always runs at high speed with the separation cutlet and ultimately becks to death.

    Check whether the rate of the drive arm of the clutch supporter cylinder and the separation dial shaft is duly acclimated. After the clutch pedal returns to its original position and the clutch supporter cylinder also returns to its original position, due to indecorous adaptation of the length of the ejector rod or the angle of the rocker arm, the release bearing can not be separated from the release cutlet, performing in the long- term contact between the release bearing and the release cutlet.

 

Views: 61