The clutch release bearing is an important part of the automobile. If the maintenance is not good and the failure occurs, it will not only cause economic losses, but also it will be quite troublesome to disassemble and assemble once, which requires a lot of man-hours. Therefore, it is necessary to find out the cause of the clutch release bearing failure and carry out reasonable maintenance and maintenance during use. It is of great significance to extend the service life of the release bearing, improve labor productivity, and obtain better economic benefits.

The clutch release bearing is installed between the clutch and the transmission. The release bearing seat is loosely sleeved on the tubular extension of the first bearing cover of the transmission. The shoulder of the release bearing is always against the release fork and retracted to the final position through the return spring, keeping a gap of about 3~4mm with the end of the release rod (separation finger).

Since the clutch pressure plate, the release lever and the engine crankshaft work synchronously, the release fork can only move axially along the output shaft of the clutch, and obviously, the release fork cannot be used to directly move the release lever. The release bearing allows the release rod to rotate side by side. The output shaft of the clutch moves axially to ensure smooth engagement of the clutch, gentle disengagement, reduce wear and extend the service life of the clutch and the entire drive train.

The clutch release bearing should move flexibly, without sharp noise or jamming, its axial clearance should not exceed 0.60mm, and the wear of the inner ring should not exceed 0.30mm.

BENWO's newly launched 6482000155 clutch release is suitable for Volvo FM FH Renault truck hydraulic release bearing. It got a good response as soon as it was new.

Its outstanding advantages include: Bearing steel adopts international standard GCr15 Heat treatment after forging and finishing to reach Rockwell hardness HRC58-61 Ultra-precision detection of arc is controlled within 1.2μ Before leaving the factory, 100% of the finished product must be inspected and the axial clearance must be strictly controlled within 35-45.

TAIZHOU BENWO AUTO PARTS CO., LTD. is a Release Bearing Manufacturer, which produces a variety of Truck Parts. Welcome to visit our official website.